Step 7: Connect Ductwork; Step 8: Connect Electrical; Step 9: Install Decorative Duct Cover - GE ZV750 Installation Instructions Manual

7
Step
connection. Doing so will prevent proper
damper operation. Seal connection with
Connect
tape only.
Ductwork
• Install ductwork, making connections in
direction of airflow as illustrated.
• Secure joints in ductwork with sheetmetal
screws.
• Wrap all duct joints with duct tape for
airtight seal.
8
Verify that power is turned off at the source.
Step
Connect
Electrical
9
Step
Install
Decorative
Duct Cover
and
Utility
Bars
Place the decorative duct cover on top of the
hood.
• Insert the lower portion of the duct cover
into the impression on the top of the hood.
• Extend the inner duct upwards to meet the
ceiling and bracket.
• Secure the duct cover to the bracket with the
2 small Phillips screws provided.
• Install the side utility bars as shown with
screws provided.
10
GE Monogram at
Call 1-800-667-8721 anywhere in the US and Canada
Do not use sheet metal
screws at hood flange
CAUTION
WARNING
If house wiring is not 2-wire with a
ground wire, a ground must be
provided by the installer.
When house wiring is aluminum,
be sure to use U.L. approved anti-
oxidant compound and alumi-
num-to-copper connectors.
Mounting Screws
::
rangehoods
Installation
• Insert house wiring through strain relief and
tighten.
• Connect white leads to branch circuit white
lead.
• Connect black leads to branch circuit black
lead.
• Connect green/yellow leads to branch
circuit green or bare ground lead.
• Secure all connections with wire nuts on
each electrical connector.
• Push wires into junction box and replace
cover. Be sure wires are not pinched.
Bottom
Notches
Install Optional ZX10SY Duct Cover
• Separate the supplied duct cover into pieces.
Discard the upper (or inner) section.
• Insert the new ZX10SY duct cover into the
original lower section. Be sure that the new
longer section is inside the shorter original
section. The notches will be at the bottom
and the screw holes at the top as illustrated.
• Follow the same procedures shown above to
install the new duct cover.
com
.
kitchen
is a division of
U N
-
36" Vent Hood
Duct Tape
Over Seam
and Screw
Screw
Air Flow
accessories
::
L I M I T E D
www.rangehoods.com