Touch Screen Board And Display Cable - HP 10 G2 2301 Maintenance And Service Manual

Touch screen board and display cable

Description
Touch screen board (includes cable)
Before removing the touch screen board, follow these steps:
1. Turn off the tablet. If you are unsure whether the tablet is off, turn the tablet on, and then shut it down
through the operating system.
2. Disconnect the power from the tablet by unplugging the power adapter cord from the tablet.
3. Disconnect all external devices from the tablet.
4. Remove the back cover (see
5. Remove the battery (see
6. Remove the speaker (see
7. Remove the rear-facing webcamera (see
8. Remove the antenna board (see
Remove the touch screen board:
1. Release the ZIF connector (1), loosen cable from channels, and then remove the touch screen board (2)
without detaching the soldered connection.
2. Disconnect the display cable (3) from the middle frame (4).
Reverse this procedure to install the touch screen board.
Back cover on page 11).
Battery on page 13).
Speaker on page 14).
Rear-facing webcamera on page
Antenna board on page
14).
16).
Touch screen board and display cable
Spare part number
829930-001
17