Table of Contents
Advertisement
6.
Release the volume button board (3) from the clips built into the back cover.
7.
Remove the volume button board and cable.
Reverse this procedure to install the volume button board.
Connector board
Description
Connector board (includes cable, micro SD Card Reader slot, and micro SIM slot)
Before removing the connector board, follow these steps:
1.
Turn off the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on,
and then shut it down through the operating system.
2.
Disconnect the power from the tablet by unplugging the power cord from the tablet.
3.
Disconnect all external devices from the tablet.
4.
Remove the top and bottom covers (see
5.
Remove the display panel assembly (see
Remove the connector board:
1.
Remove the Phillips PM1.4×2.5 screw (1) that secures the battery cable bracket to
the system board.
2.
Remove the battery cable bracket (2).
Top and bottom covers on page
Display panel assembly on page
Spare part number
775648-001
15).
16).
Connector board
25
Advertisement
Table of Contents
