Fuses - Arctic Cat ATV 300 DVX Operator's Manual

! WARNING
Do not attempt to remove the bulb
when it is hot. Severe burns may
result.
To replace the headlight bulb, use the fol-
lowing procedure.
1. Remove the rubber boot from the
back of the headlight housing; then
remove the three-wire connector
from the bulb.
2. Release the two ends of the spring clip
from the headlight housing taking care
not to bend or deform the clip; then
remove the bulb from the housing.
3. Install the new bulb into the hous-
ing; then secure with the spring clip.
68
4. Connect the three-wire connector to
the bulb; then install the rubber boot.
CAUTION
When replacing the headlight bulb,
be careful not to touch the glass
portion of the bulb. Grasp the new
bulb with a clean cloth.
To replace the taillight/brakelight bulb,
use the following procedure.
1. Remove the two screws and remove
the lens.
KM194A
2. Push the bulb in and turn it counter-
clockwise.
3. Install the new bulb by turning it
clockwise while pushing in.
4. Install the lens. Tighten the two
screws securely.

Fuses

The fuse box (with three active fuses and
one spare fuse) is located under the seat
near the battery.
KM192A
 NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse cover and lift off;
then remove and replace the fuse.
KM195
KM143B
KM102