Air Filter Housing Drain Tube; Drive Chain (Dvx) - Arctic Cat ATV 300 DVX Operator's Manual

9. Clean any dirt or debris from inside
the air cleaner. Be sure no dirt enters
the carburetor.
10. Install the foam element into its
frame; then place the assembly into
position in the housing and secure
with the retaining nut.
11. Install the cover and secure with the
retaining clips.
12. Install the seat making sure it is
properly secured.
Air Filter Housing Drain
Tube
Periodically (weekly) check the drain
tube for gasoline or oil accumulation. If
noticed, remove the drain tube cap from
beneath the housing, drain the gasoline or
oil into a suitable container, and install
and secure the tube cap.

Drive Chain (DVX)

Drive chain condition and adjustment
should be inspected each day before you
ride. Always follow the guidelines below
for inspecting and servicing the drive chain.
! WARNING
Failure to inspect and maintain the
drive chain can be hazardous. Oper-
ating the ATV with the drive chain in
poor condition or
adjusted can cause an accident
resulting in possible injury.
Inspecting Condition
Inspect the drive chain for any of the fol-
lowing conditions.
• Loose pins
• Loose or cracked rollers
• Dry or rusted links
• Kinked or binding links
• Excessive wear
The presence of any of the conditions
requires drive chain replacement. Take
the ATV to an authorized Arctic Cat ATV
dealer for this service.

NOTE: If the drive chain is worn
or damaged, the sprockets may
also be worn or damaged. Inspect
the sprockets for worn, broken, or
damaged teeth. Always inspect the
sprockets when a new drive chain
is being installed.
Cleaning and Lubricating
The drive chain should be cleaned and
lubricated frequently to prolong chain
and sprocket life. Use the following pro-
cedure to clean and lubricate the chain.

NOTE: This ATV is equipped with
an O-ring type roller chain. Each
link incorporates small O-rings to
seal out water and dirt. Care should
be taken to choose cleaning solu-
tions and lubricants that are suit-
able for O-ring chains.
1. Using a suitable, nonflammable
cleaning solution, thoroughly wash
the chain and sprockets.
2. Allow the chain to dry; then apply a dry,
graphite-based lubricant to the chain.
KM114
The drive chain should be lubricated with
a dry, graphite-based chain lubricant. By
using a dry, graphite-based chain lubri-
cant, dirt buildup on the drive chain will
be minimized.
Adjusting Tension
To adjust the drive chain tension, use the
following procedure.
improperly
KM157A
65