Hand Brake Lever - Arctic Cat ATV 300 DVX Operator's Manual

Hand Brake Lever

The hand brake is considered to be the
normal operating (main) brake.
The hand brake should be applied when-
ever braking is needed.
Apply the brake by compressing the lever
toward the handlebar.
Brake Lever Lock
To engage and release the brake lever
lock, use the following procedure.
44
KM203A
1. Squeeze the hand brake two or three
times and release it.
2. Push and hold the brake lever lock.
3. While pushing forward on the brake
lever lock, squeeze the brake lever.

NOTE: It will click as it engages
and the brake lever will not return to
its released position.
4. Release the brake lever lock by
KM124A
squeezing the brake lever. It will
return to its released position.
Check to make sure the brake lever lock
engages properly and that the brake
(when engaged) locks the wheels.
1. Pump the brake lever 2 or 3 times.
2. Engage the brake lever lock.
3. Attempt to push the ATV.

NOTE: The brake lever lock must
lock the wheels. If it doesn't, take
the ATV to an authorized Arctic Cat
ATV dealer for service.
! WARNING
Always check to be sure that the
brake lever lock has been disengaged
before operating the ATV. An accident
KM161A
could result if the brake lever lock is
left engaged while the ATV is operated
due to overheating of the brake sys-
tem.
KM161B