Arctic Cat ATV 300 DVX Operator's Manual page 50

2. Mode/Set Button (2) - In conjunc-
tion with Mode/Set Button (1), shifts
the LCD through mode and reset
operations.
3. Coolant Temperature Indicator
(3) - Displays approximate engine
coolant temperature.

NOTE: Normal operating range is
from the bottom segment (C) up to
but not including the top segment
(H). In the event the top segment (H)
is displayed, all segments of the
display and the temperature icon
will flash indicating high engine
temperature.
CAUTION
Continued operation of the ATV with
high engine temperature may result
in engine damage or premature wear.

NOTE: High engine RPM, low vehi-
cle speed, or heavy load can raise
engine temperature.
engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the temperature.

NOTE: Debris in front of the
engine (or packed between the
cooling fins of the radiator) can
reduce cooling capability. Using a
garden hose, wash the radiator and
the engine to remove any debris
restricting air flow.
CAUTION
Arctic Cat does not recommend using
a pressure washer to clean the radia-
tor core. The pressure may bend or
flatten the fins causing restricted air
flow, and electrical components on
the radiator could be damaged. Use
only a garden hose with spray nozzle
at normal tap pressure.
4. Speedometer (4) - Displays approx-
imate vehicle speed in mph or km/h.
48

NOTE:
between mph and km/h, press the
Mode/Set Button for two seconds.
The LCD will display either mph or
km/h on the right-side of the dis-
play. The Odometer/Trip Meter (7)
will shift to correspond (miles/kilo-
meters) with the speedometer.
5. Fuel Level Indicator (5) - Indicates
approximate amount of gasoline in
the gas tank.

NOTE: When the bottom segment
flashes, gasoline quantity is low.
6. Digital Clock (6) - Displays time in
hours and minutes when the ignition
switch is turned to the ON position.
To set the time, turn the ignition
switch to the ON position; then use
the following procedure.

NOTE: If the Hour Set or Minute
Set operation is interrupted for
more than 10 seconds, the clock
will return to normal operation.
Decreasing
A. Hour Set: Press and hold Mode/
Set Buttons (1) and (2) until the
hour
release both buttons and again
press Mode/Set Button (2) to
select the desired hour. When
the desired hour is displayed,
release the button.

NOTE: The clock displays a
sequential 24-hour time only. There
is no 12-hour AM/PM designation.
B. Minute Set: Press and hold
Mode/Set Button (1) until the
minute display flashes; then
release the button and press
Mode/Set Button (2) to select
the desired minute. When the
desired minute is displayed,
release the button.

NOTE: When the button is released
for more than 10 seconds, the clock
will return to normal operation.
To shift the display
display flashes; then