Clear Program Features (Addr 1197 & 1198); User Program Mode; Preliminary Information - NAPCO Gemini GEM-P816 Programming Instructions Manual

WI995C 2/04
CLEAR PROGRA M O PTI ONS (AD DRESS 1197 & 1198)
1197 XX
1198 XX

USER PROGRAM MODE

PRELIMINARY INFORMATION

The User Program Mode is covered in detail in the operating instructions for the keypad in use.
!
Only Keypad #1 may be used for programming, however this keypad may be located in any area.
!
The Program Mode cannot be accessed while the communicator is transmitting except during the first three minutes after power-
up.
!
After entering codes or data, press the save
!
If the keypad is in the Program Mode and no activity is detected for longer than 4 minutes, a steady tone will sound.
NOTE: For ease of programming, it is recommended that a GEM K1CA (or GEM-RP1CAe2) be used as Keypad #1. A new GEM-
K1CA and a new GEM-RP1CAe2 are automatically configured as Keypad #1. See Keypad Configuration Mode.
!
Press the C button to silence the sounder and exit the User Program Mode.
If a GEM-RP2ASe2/GEM-K2AS keypad is used, configure address jumpers as Keypad #1 (See WI1182).
L
NAPCO Security Systems
Clear Dealer Program (Erases Dealer Program)
H
This erases the dealer program. Use this feature to start
a customized default program. Program Data and Sys-
tem Status Memory is erased where Scheduled Data and
Zone Descriptions are maintained.
Access address 1197, then press
NOTE: Enter Easy Menu Driven Program Mode to program system
again.
Cold Start (Erases Entire Program)
H
This erases the entire program including Dealer Program
by erasing Program Data, Zone Description Data and
System Status Data (similar to a new panel).
Access address 1198, then press
NOTE: Some features (schedules) can only be programmed again with
the Downloading Software.
U
button. Data will not be stored into memory unless this button is pressed.
U
. Data entry is not allowed.
U
. Data entry is not allowed.
X
GEM-P816 Programming Instructions
!
Page 31