Clear Program; Cold Start - NAPCO GEM-P1664EX Programming Instructions Manual

Page 12
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press the
Address Program Mode for further programming or press
operation.
CLEAR PROGRAM: Should it be necessary to create a new custom default program, (a) from the Dealer Program Mode, press
to enter the Address Program Mode; (b) access Location 2285 (Clear Program) or 2286 (Cold Start); (c) press
C
(d) press to exit the Dealer Program Mode. A "SYSTEM TROUBLE/E09-00 SERVICE" will occur. Press
C
keypad.
2285 XX
(Direct Entry)
Driven Program Mode to program system again.
2286 XX
(Direct Entry)
(schedules) can only be programmed again with the Downloading Software.
X
GEM-P1664EX Programming Instructions
Clear Dealer Program (Erases Dealer Program)
This erases the dealer program. Use this feature to start a customized default program. Program
Data and System Status Memory is erased where Scheduled Data and Zone Descriptions are
maintained.
Access address 2285, then press the
Cold Start (Erases Entire Program)
This erases the entire program including Dealer Program by erasing Program Data, Zone Description
Data and System Status Data (similar to a new panel).
Access address 2286, then press the
once again to end all programming and resume normal keypad
C
U
button. Data entry is not allowed. NOTE: Enter Easy Menu
U
button. Data entry is not allowed. NOTE: Some features
WI1387 7/05
button to enter the Direct
C
U
to silence the
C
L
NAPCO Security Systems
and then