Incline Motor Replacement - Matrix T5X-04 Service Manual

CHAPTER 9: PART REPLACEMENT GUIDE
9.11 INCLINE MOTOR REPLACEMENT - CONTINUED
4) Disconnect the incline motor power cable from the MCB (Figure D).
5) Disconnect the pin from the incline motor (Figure E).
FIGURE D FIGURE E
6) Lift the incline motor away from the treadmill (Figure F).
7) Reverse Steps 1-6 to install a new incline motor. NOTE: When installing the new incline motor, make sure to replace the white washers at
the top and bottom (Figure G).
FIGURE F FIGURE G
8) Auto Calibration must ALWAYS be run after replacing the incline motor (see Section 3.4).
43