Table of Contents
Advertisement
10
Load bearing underlay
The Scan 85 series weighs from 204 kg to 220 kg. You should there-
fore make sure that the underlay can bear the weight of the wood-
burning stove and that of the chimney.
Floor plate
If you are setting up the stove on a flammable floor, observe national
and local regulations on the size of the non-flammable underlay that
covers the floor around the stove.
Your local Scan dealer can advise you on regulations concerning
flammable materials in the vicinity of your stove.
The idea behind the floor plate is that it protects the floor and flam-
mable material against sparks.
The floor plate can be made of steel or glass, and the stove can be set
up on brick, natural stone or similar materials.
This Scan wood-burning stove has an integrated floor plate, and
can thus be set up on any flammable material without a protective
underlay.
Small shaped floor plate for the Scan 85 series
Large shaped floor plate in steel or large base floor plate in glass
for Scan 85 series
Scan 85 med lille formgulvplade
Scan 85
NAVN:
EMNE:
MATERIALE:
DIMENSION:
C:\Working Folder\Designs\Scan85\90585007.idw
STI:
A S S E M B LY
90585007
TG.NR:
216,09 kg
22-02-11
VÆGT:
DATO:
SIGN:
18956166 mm^2
AREAL:
Krog Iversen & Co A/S
DK-5492 Vissenbjerg©
Existing chimney and pre-fabricated element
chimney
If you intend to connect your stove to an existing chimney, it makes
sense to contact an authorised Scan dealer, or a local chimney sweep
for advice. These experts will also let you know if your flue needs
renovating.
When connecting a pre-fabricated element chimney, follow the
manufacturer's connection instructions for the relevant chimney
type.
Connection between stove and steel chimney
Your Scan dealer, or local chimney sweep, can advise you on choosing
a make and type of steel chimney. This ensures that the chimney will
match your wood-burning stove. As a general rule, the length of the
flue should not be less than 4 m measured from the top of the wood-
burning stove.
Some weather or installation conditions might require another
length.
Choosing the wrong length or diameter of steel chimney could
impair functionality.
Always observe the chimney vendor's instructions precisely.
Requirements for chimney
The chimney must be labelled T400 and G for soot testing.
Connection with 90° elbow pipe
If you connect the Scan 85 series with an elbow pipe, you should use
a curved elbow, as this gives a better draught.
BC
Scan 85
NAVN:
EMNE:
MATERIALE:
DIMENSION:
Scan 85 med knærør
N/A
VÆGT:
DATO:
N/A
AREAL:
90585009
TG.NR:
06-09-10
BC
SIGN:
Hide quick links:
Advertisement
Table of Contents
