Adjusting The Audio Input Level - Panasonic AG-DVX200PJ Operating Instructions Manual

To remove the external microphone, etc., from the AUDIO INPUT1, 2 terminals
(XLR 3 pin)
Remove while pushing on the PUSH section of the AUDIO
INPUT1, 2 terminals (XLR 3 pin).
≥ Set the input signal to built-in microphone by switching
the CH1 SELECT, CH2 SELECT switches to INT (L) or
INT (R) after removing the external microphone. Audio
will not be recorded when motion picture is recorded
without switching.
≥ Set INPUT1, 2 switches to LINE or MIC if you connect equipment not compatible with
+48 V. You can damage this unit or such equipment if you leave the setting at +48V.
≥ This unit is turned off when a problem occurs with the +48 V power supply.
≥ The battery will discharge faster if you use a phantom microphone.

Adjusting the audio input level

Selecting an adjustment method
You can set how to adjust the audio input level for each audio channel. Use the CH1 switch for
channel 1 and the CH2 switch for channel 2.
1
Set the position of the CH1 or CH2 switch.
AUTO
:
MANU
:
2
(If you have set to MANU)
Adjust the input level operating the AUDIO LEVEL CH1/AUDIO LEVEL CH2
knobs.
≥ Adjust confirming the audio level meter.
Adjusts the level automatically.
Adjusts the level manually.
A AUDIO LEVEL CH1/AUDIO LEVEL CH2 knobs
B Audio level meter
C -12 dB
D 0 dB
- 68 -
A PUSH section
CH1
AUDIO LEVEL
CH2