Table of Contents
Advertisement
To remove the external microphone, etc., from the AUDIO INPUT1, 2 terminals
(XLR 3 pin)
Remove while pushing on the PUSH
section of the AUDIO INPUT1, 2 terminals
(XLR 3 pin).
≥ Set the input signal to built-in
microphone by switching the CH1, CH2
switches to INT (L) or INT (R) after
removing the external microphone. Audio
will not be recorded when motion picture
is recorded without switching.
≥ Set INPUT1, 2 switches to LINE or MIC if you connect equipment not compatible with
+48 V. You can damage this unit or such equipment if you leave the setting at +48V.
≥ This unit is turned off when a problem occurs with the +48 V power supply.
≥ The battery will discharge faster if you use a phantom microphone.
Adjusting the audio input level
Selecting an adjustment method
You can set how to adjust the audio input level for each audio channel. For audio channel 1, select
[AUDIO LEVEL CH1]; for audio channel 2, select [AUDIO LEVEL CH2].
1
Select the menu.
MENU
: [AUDIO SETUP] # [AUDIO LEVEL CH1] or [AUDIO LEVEL CH2] # desired setting
[AUTO]
:
[MANUAL]
:
2
(If you have set to [MANUAL])
Adjust the input level operating the AUDIO LEVEL CH1/AUDIO LEVEL CH2
knobs.
≥ Adjust confirming the audio level meter.
Adjusts the level automatically.
Adjusts the level manually.
A AUDIO LEVEL CH1/AUDIO LEVEL CH2 knobs
B Audio level meter
C -12 dB
D 0 dB
- 58 -
A PUSH section
CH1
AUDIO
CH2
Advertisement
Table of Contents
