External Monitor - Panasonic AG-DVX200PJ Operating Instructions Manual

External monitor

You can connect this unit to an external monitor as shown in the figure below.
A HDMI Cable (optional)
B BNC Cable (commercially-available)
C Audio cable (commercially-available)
D External monitor
≥ By connecting this unit to a 4K-compatible external monitor with HDMI Cable and play back
scenes recorded with their size set to 4K (4096k2160) or UHD (3840k2160) in [REC FORMAT],
you can enjoy finely-detailed 4K motion pictures. For an external monitor that does not support
4K motion picture, you can change the [RESOLUTION] or [HDMI UHD OUTPUT LIMIT] setting
so that 4K motion pictures can be played back at a lower resolution.
≥ If you set [REC FORMAT] to [UHD 2160/59.94p 150M] or [UHD 2160/50.00p 150M] in Recording
Mode and then connect this unit to a 4K-compatible external monitor with an HDMI cable, images
will be output in 3840k2160 when recording is stopped and in 1920k1080 during recording or
PRE-REC. Please note that the image on the screen of this unit and on the external monitor
disappears for a few seconds every time you start or stop recording or every time you switch the
PRE-REC on/off.
These irregularities do not occur when [RESOLUTION] is set to [1080p] or [1080i], which outputs
images in 1920k1080.
When connecting with an HDMI cable using an HDMI-to-DVI converter, etc., be sure to
connect the HDMI cable to the connector of this unit last.
Connecting the HDMI cable to the connector of this unit first may result in malfunction.
≥ This unit is not compatible with the VIERA Link.
≥ Use a commercially-available High Speed HDMI cable.
If possible, we recommend using a cable with a length of 3 m (9.84 feet) or less.
≥ Use a commercially-available, double-shielded BNC cable equivalent to 5C-FB.
SDI
OUT
AUDIO
OUT
VIDEO
OUT
3.5 mm (0.14 q) diameter jack to RCA cable




- 114 -
