Panasonic AG-DVX200PJ Operating Instructions Manual page 71

[DF MODE]
Select the compensation mode for the time code.
≥ Set [SYSTEM FREQ] to [59.94Hz].
Select the menu.
MENU
: [RECORD SETUP] # [DF MODE] # desired setting
[DF]:
[NDF]:
≥ This item will be set to [NDF] automatically in following cases:
j When the frame rate in [REC FORMAT] or [OUTPUT FORMAT] is 23.98p or 24.00p
147)
j During the Interval Recording
≥ This item will be automatically set to [NDF] and will not be displayed as a menu item when
[SYSTEM FREQ] is set to [50.00Hz].
[TCG]
Sets the way the time code will move.
Select the menu.
MENU
: [RECORD SETUP] # [TCG] # desired setting
1
[FREE RUN]* :
[REC RUN]:
*1 If the frame rate in [REC FORMAT] or [OUTPUT FORMAT] is set to 23.98p, a slight time error
may occur when switching to Playback Mode.
≥ It is automatically set to [FREE RUN] in following cases:
j When PRE-REC is enabled
j When [2 SLOTS FUNC.] is set to [BACKGROUND]
≥ It is automatically set to [REC RUN] in following cases:
j In Variable Frame Rate Mode*
j During the Interval Recording
*2 [FREE RUN] is also available if the number of frames for the frame rate in [REC FORMAT] and
the number of frames for Variable Frame Rate Mode are the same.
Example: When [REC FORMAT] is set to [FHD 1080/59.94p 50M] and the frame rate is set to
[60]
≥ The time code will reset when the built-in lithium battery is exhausted when it is set to
[FREE RUN].
(l 141)
Time code is compensated in accordance with the actual time. It is
mainly used for broadcasting such as TV programs.
It will not compensate the time code. (There will be a difference from
the actual time)
(l 162)
(l 141)
It will constantly move.
It will move only when recording.
(l 86, 163)
2
(l 91)
(l 162)
- 71 -
(l 142, 147)
(l 159)
(l 142,