Hardware; Led Description; Max Led; Table 1. Led Description - Advantech B&B SmartWorx ESWGP506-2SFP-T User Manual

HARDWARE

LED DESCRIPTION

Device Face

Table 1. LED description

MAX LED

The end user can set the PoE+ power to a particular value per port. This is done through the software.
Please refer to the software section for configuration settings. The MAX LED is ON when the PoE power
consumption is near the maximum load, which is configured through the software. The information for
MAX load is located in the PoE Management Configuration
LED Status
PWR (P1, P2) Green ON
PWR (P1, P2) Green OFF
STA Green Flashing
Green ON/OFF
Console NO LED
MAX Green ON
Green Flashing
Green OFF
SPD Green ON
Orange ON
LED with No Light
LNK Green ON
10/100/1000
Green Flashing
copper
Green OFF
SFP Green On
Green Flashing
Green OFF
POE+(1/2/3/4) Green On
Green Flashing
Green OFF
section.
12
Description
Power applied to Port
No power to Port
System is UP, passing data
System is DOWN
RJ-45 connection for a CLI
using a hyperterminal prgm.
PoE power over max load
PoE power over max load
PoE power within max load
1000Mbps
100Mbps
10Mbps
Link has been established
Activity
Not connected to network
1000Mbps
Activity
Not connected to network
PoE port providing power
Port overload/short circuit
or fail at startup
PWR not supplied