Advantech B&B SmartWorx ESWGP506-2SFP-T Quick Start Manual

Product Overview
Power
LEDS
10/100 /1000
Copper
POE+ Ports
SFP Ports
About Power
1
Redundant power inputs accept 24-52VDC.
Power consumption is 135W.
If redundancy is desired, you may connect two separate
power supplies by using the two DC inputs on the terminal
blocks.
About the Ports
2
RJ-45 Ports
The RJ-45 ports auto-negotiate for
10/100/1000Mbps device connections. The
Auto Cross feature allows connections to switches,
workstations, and other equipment without changing
straight through or crossover cabling.
SFP Ports
The SFP ports support 1000Mbps Single Mode or
Multi Mode SFPs, as long as they are MSA-compliant.
Port 5 also supports copper SFPs as long as they are
MSA-compliant.
PoE+ Ports
The PoE+ ports on this switch follow Alternative A standards
and support up to 30 Watts of power output per port.
Ports 1 thru 4 support the IEEE802.3at standard and are
classified as PSE power sourcing equipment, which means
they can be used to power (PD) powered devices.
3
POE ON/OFF RESET: To reset/disable PoE, set DIP
Frame or
switch #1 to ON. (The default setting is OFF.)
Earth Ground
POE AUTO RESET: to enable/disable the PoE auto
reset function, set DIP switch #2 to ON. (The default
setting is OFF.)
When Auto Reset is ON, the PoE function will shut
down if both SFP ports lose link, to save power.
4
When the network cables are attached and power
is applied, installation is complete. The switch will
automatically discover network devices, populate
its MAC address table, and pass traffic to the
appropriate ports.
PoE Reset Function
Device Discovery
LED Status
5
LED Status Description
Green PoE power nearly reaching
On max load
Green
MAX
PoE power over max load
Flashing
Green
PoE power within max load
Off
Green
System is UP, passing data
Flashing
STA
Green System is UP/System is
On/Off DOWN
Green
Power applied
On
PWR
(P1, P2)
Green
No Power
Off
Green
1000Mbps
10/100
On
1000
Orange
Copper
100 Mbps
On
SPD LED
LED Off 10 Mbps
Green
Link
On
10/100
Green
1000
Activity
Copper Flashing
LNK LED
Green
Not connected to network
Off
Green
1000Mbps
On
Green
SFP LED Activity
Flashing
Green
Not connected to network
Off
Green
PWR Supplied
On
Green Port overload/short circuit
PoE+
Flashing or fail at startup
Green
PWR Not Supplied
Off