Advantech ESWGP510-2SFP-T Quick Start Manual

Product Overview

Power
LEDS
10/100/1000
Copper

POE+ Ports

SFP Ports

About Power

1
Redundant power inputs accept 44-57 VDC.
Power consumption is 255 W.
If redundancy is desired, you may connect two separate
power supplies by using the two DC inputs on the terminal
blocks.

About the Ports

2
RJ-45 Ports
The RJ-45 ports auto-negotiate for
10/100/1000Mbps device connections. The
Auto Cross feature allows connections to switches,
workstations, and other equipment without changing
straight through or crossover cabling.
SFP Ports
The SFP ports support 1000 Mbps Single-mode or
Multi-mode Fiber SFP's and 1000Mbps copper SFP's
as long as they are MSA-compliant.
PoE+ Ports
The PoE+ ports on this switch follow Alternative A standards
and support up to 30 Watts of power output per port.
Ports 1 thru 8 support the IEEE802.3at standard and are
classified as PSE power sourcing equipment, which means
they can be used to power (PD) powered devices.
3
POE ON/OFF RESET : To reset/disable PoE, set DIP
switch #1 to ON. (The default setting is OFF.)
POE AUTO RESET : To enable/disable the PoE auto
Frame or
reset function, set DIP switch #2 to ON. (The default
Earth Ground
setting is OFF.)
When Auto RESET is ON, the PoE function will shut
down if both SFP ports lose link, to save power.
4
When the network cables are attached and power
is applied, installation is complete. The switch will
automatically discover network devices, populate
its MAC address table, and pass traffic to the
appropriate ports.
PoE Reset Function

Device Discovery

LED Status

5
LED Status Description
Green
Relay Closed
On
FAULT
Green
Relay Open
Off
Green
System ON
Flashing
STA
Green
System down
On/Off
Green
Power Applied
On
PWR
(P1, P2)
Green
No Power
Off
Green
1000 Mbps
10/100
On
/1000
Orange
Copper
100 Mbps
On
SPD LED
LED Off 10Mbps
Green
Link
On
10/100
/1000 Green
Activity
Copper
Flashing
LNK LED
Green
Not connected to network
Off
Green
Link
On
Green
SFP LED
Activity
Flashing
Green
Not connected to network
Off
Green
PWR Supplied
On
Green Port overload/short circuit
PoE+
Flashing or fail at startup
Green
PWR Not Supplied
Off