Function Of Receiver; Adjustment Of Receiver; Matters Needing Attention - Walkera W100S User Handbook Manual

2. 1
-MHz
6.2 Function of receiver
S/N Full name Function Connection
1 B front motor Connect to the B front motor wire. Terminal is facing right.
2
A back motor Connect to the A back motor wire. Terminal is facing right.
3
B back motor Connect to the B back motor wire. Terminal is facing right.
4
A front motor Connect to the A front motor wire. Terminal is facing right.
5
Power wire Connect to the lipo battery.
6
Upgrade channel one
a. Upgrade spare;
b. Connect with the Wi-Fi module signal wire;
c. Connects to the plug of TX5805/TX5806
(FCC) transmitter power wire;
Terminal is facing left.
7
Upgrade channel two
Upgrade spare or insert the bind plug to
clear the ID memory.
Terminal is facing left.
8
Signal indicator light Display the status of received signal.
9
Gyro sensitivity
adjust knob
Adjust the gyro sensitivity of the front/back
/left/right /tail.
6.3 Adjustment of receiver
(1) Adjust knob of the gyro: CW rotating increase the sensitivity of the Gyro, CCW rotating decrease the sensitivity
of the Gyro. The default setting is Middle, generally there is no need to trim.
(2) Clear fixed ID in receiver: Insert plug terminal into upgrade channel two of the receiver to clear fixed ID
memory and disconnect plug terminal when the indicator of the receiver start to slowly flash.
(3) Receiver upgrade:
(3.1) QR W100S control program upgrade can be downloaded online at Walkera Offical Website:www.walkera.com.
(3.2) QR W100S control program upgrade tool includes UP02 cable and UP02 Adapter.
UP02 Adapter UP02
(3.3) Plug the three colored cable (black, red and blue) into upgrade channel one and plug the three colored
cable (black, red and yellow) into upgrade channel two (fixed ID may clear after upgrading).
Front t
RX2646H-DS
0
Upgrade channel two
Upgrade channel one
black, red and yellow
black, red and blue
UP02
UP02 Adapter
6.4 Matters needing attention
Back
(1) All the wires should be connected in a correct way. Misconnection will result in failure to receive signal, even
damage to the receiver.
(2) Please use special adjustment pen to rotate the gyro tuning knob in order to not damage the knob.
(3) The QR W100S must be still and place in a horizontal position when matching code.
LJ
06
Setup of the
RX2646H-DS
receiver
5