Ready To Fly; Starting The Aircraft / Get Binding - Walkera RUNNER 250 PRO Quick Start Manual

Right red LED
Zri2=50
Quick Start Guide
8.0 Ready to Fly
Attention:
• Place the aircraft in a wide open space, with the rear facing you.
(This position is known as "TAIL IN")
• Put all the function switches to the 0 position, put all trims and dials to the Middle position,
move the throttle to the lowest position, then turn on the Remote Controller.
• A video receiving equipment is needed( such as Goggles glasses, etc. ) to display
an image and OSD information. (Setting method please refer to P15)
• The RUNNER 250 have a low-voltage alarm beeper.
And the OSD give you a visual reference for the remaining battery power.
When voltage reach below 10.8 volts the LEFT red LED lights will flash slowly and the beeper
will sound alarm.
WARNING: Do not hesitate to land when you hear the alarm or see the OSD indicating 10.8 volts.
8.1 Starting
the aircraft / Get binding
Turn on the Remote Controller. (Make sure all the
function switches, all trims/knobs and throttle stick
at the lowest position)
0 Put the aircraft to the horizontal place and connect
the aircraft power. (make sure the positive and
negtive connected correctly)
® The red LED light on the left of aircraft flashes slowly
until goes out, indicating that the IMU preheating
is complete and the code binding is successful.
If it issuing the sound of "BB" that it is fail to IMU
preheating. Pls restart the aircraft.
V;
Tips:
• Do not move the aircraft during start-up.
• ALWAYS unfold the two reciever anteannas to
their correct STRAIGHT UP position before flying.
Do not fly without properly unfolding the antennas.
-8-