Table of Contents
Advertisement
Starlight QUICK START GUIDE
10.0 Prepare for Aircraft
Install the gimbal and camera
Slide the gimbal and camera
along the chute, and the gimbal
will automatically lock.
11.0 R eady for Flight
Before you plan to fly, please download the map in the APP (turn off the aircraft power,and
connect internet, click the " A thumbnail map icon" to download the map).
Place the aircraft in an open outdoor area, with its tail facing the operator.
11.1 Start the aircraft &Get code binding
1)Open the battery compartment cover
and make sure that the battery pressure
block is turned to the open position
shown in the figure above.
4)Turn on the remote controller.
Tips: When the code is being checked, if the red and green LED lights keep flashing fast, it means the aircraft
is abnormal, please refer to the APP tips.
10
Insert a MicroSD memory card
(notch facing the tail of the aircraft).
2)Align the battery interface with the
battery interface seat and install it
in the battery compartment.
5)Turn on the aircraft power switch
and close the battery compartment
cover.
Walkera All Rights Reserved
Press
H ow to take out:
Hold down the
unlock buttons on both sides and
pull the gimbal toward the front of
the aircraft.
3)Turn the battery pressing block to
the pressing position.
6)Rest the aircraft in a horizontal position.
Red LED lights flash alternately until
it is steady on, indicating the completion
of IMU preheating and successful
alignment.
Press
Red LED
Advertisement
Table of Contents
