Table of Contents
Advertisement
1. Push and pull the Elevator
2. It is in Normal Flight mode when the red indicator flashes
stick up and down four times
quickly, and it's in Roll Flight mode when the green
or more(finish in 2 second)
indicator flashes quickly.(The Flight Mode can be changed)
Step 1
Step 2
Step 3
Step 4
Step 1: Open the battery compartment, Install the battery pack into
the battery compartment along the arrow direction.
Step 3: Pull down the throttle stick and throttle trim of transmitter to
the lowest position, and then move the elevator trim, aileron
trim, and rudder trim at the neutral positions, respectively.
Step 4: Connect the power cable of UFO to
receive signal from transmitter.
Step 2: Turn on the power of transmitter.
09
Transmitter
control
2-aiGHz
(2) In Flight Mode switch status, push and pull the Elevator Stick up and down four times or above to change
the Flight Mode(Finish within 2 seconds). If red indicator flashes quickly, it's normal flight mode. If green
indicator flashes quickly, it's roll flight mode.
(3) After choose the Flight Mode, pull the throttle stick at the lowest position, then flight available.
9.4 Turn on the power
9.4.1 Turn on the power
9.4.2 Matters needing attention
(1) Please follow the rule: Power on the radio first then connect the battery of the quadcopter. After power on
the radio, connect the UFO battery in 10 seconds, the indicator starts flashing. the indicator becomes solid
after 1 to 3 seconds. After binding with the radio, the red indicator flash quickly means the radio binding
successfully.
(2) If more than 10 seconds passed before the power cable was connected binding will fail. When binding fails,
disconnect the battery, tum off the transmitter and repeat step (1).
9.4.3 Trouble shooting a flashing receiver LED after connecting the power cable
Possible causes
Solutions
Code pairing failed.
Turn transmitter off then on and re-connect UFO
power cable.
The throttle trim and throttle stick of transmitter
are not at the lowest position.
Pull down the throttle trim and throttle stick to the
lowest position and re-code pair.
The transmitter battery is low or empty.
Replace transmitter battery and re-code pair (re-bind).
The UFO battery is low or empty.
Replace the UFO battery with a fresh pack and re-code pair.
No function in receiver or transmitter.
Replace faulty receiver or transmitter and re-code pair.
13
Advertisement
Table of Contents
