Reset; Throttle Curve , Dual Rate And Exponential Curve: No Need To Set; Operating Methods; Manual Flight Control - Walkera W100S User Handbook Manual

10
MTC-01
control
Q
cc3
wzoocl
2-ziGHz
10.4.7 Reset: All the settings will renew to factory settings when you Press this key.
10.4.8 Throttle curve , Dual Rate and Exponential curve: no need to set.
10.5 Operating methods
10.5.1 Manual flight control (take Mode 1 as example)
(1) Throttle stick control: Press and hold the throttle
control ball and then pushed up, the motor rotates,
the higher it push, the faster the motor will rotate(fly
higher); The motor will slow down when push down,
the lower it push, slower the motor rotates.
(2) Aileron stick control (left and right): When moving
the AILE control ball left, the UFO accordingly
flies left; When moving the AILE control ball right,
the UFO accordingly flies right.
(3) Elevator stick control(forward and backward):
When moving the
ELEV
control ball up, the UFO
accordingly flies forward; When moving the ELEV
control ball down, the UFO accordingly flies
backward.
(4) Rotate control: When moving the RUDD contro
ball left, the UFO accordingly rotate left(CCW)
When moving the RUDD control ball right, the
UFO accordingly rotate right(CW).
10.5.2 Gravity sensor control when flying( take sample for mode 1)
Touch the gravity sensor button on the screen, colorful is ON while gray is OFF. Please refer to below Illustration:
Gravity Sensor key Non Active status Gravity Sensor key Active status
21