With Devo-6/7/7E/8S/10/12S/F7 Radio; With 2402D Radio - Walkera W100S User Handbook Manual

(2) In Flight Mode switch status, push and
pull the Elevator Stick up and down four
times or above to change the Flight Mode
(Finish within 2 seconds). If red indicator
flashes quickly, it's normal flight mode.
If green indicator flashes quickly, it's roll
flight mode.
1. Push and pull the Elevator 2. It is in Normal Flight mode when the red
stick up and down four times indicator flashes quickly, and it's in Roll Flight
or more(flnish in 2 second)
mode when the green indicator flashes quickly.
(The Flight Mode can be changed)
2. Turn on the 3. Turn on the radio and 4. After code pairing
transmitter
connect the UFO battery, successfully,
then comes to the code disconnect the
pairing status. UFO battery
6. Connect the UFO
battery then comes
to the code pairing
status again.
7.After code pairing
successfully, the
receiver indicator will
flash between red and
green alternately.
1. Push the TX throttle stick to the top position
09
c):
2.AIG Hz
(3) After choose the Flight Mode, pull the throttle stick at the lowest position, then flight available.
9.3.2 With DEVO-6/7/7E/8S/10/12S/F7 radio
Note:
Please set the FMOD switch as "ACTIVE" in the Output setting of Transmitter.
Type
Channel
Mode Status
DEVO-6 Gear
FMOD Switch
Active
DEVO-7
AUX2 FMD ACT
DEVO-7E
AUX2 FMOD Switch
Active
DEVO-8S
AUX2 FMOD Switch Active
DEVO-10
AUX2 FMOD Switch
Active
DEVO-125
AUX2 FMOD Switch Active
DEVO-F7
AUX2 FMOD Switch Active
When the FMOD Flight Mode switch of the radio at "0" position, the receiver's red indicator
of Flight Mode turns solid as the Normal Flight Mode; and turns to normal flight mode; When
the FMOD mode switch of the radio at "2" position, (DEVO 7E at "1" postion), the receiver's
green indicator of Flight Mode flashing and turns solid as the Roll Flight Mode.
9.3.3 With 2402D radio
Note:Please strictly refer to below operations.
(1) Push the throttle stick to the top position, turn on the radio and connect the UFO battery , then comes to
the code pairing status.The receiver indicator of Flight Mode will flash between red and green alternately
after code pairing successfully. That's the Flight Modes switch status.
2. Turn on the transmitter 3. Connect the power
of the QR W100S
4. Begin the code
pairing process
5. The indicator of Flight Mode will
flash between red and green
alternately.
12