Power Rating; Regulatory Notices - Polycom realpresence group series Setup Sheet

Attach the cables to the codec, display, and speaker/
21
subwoofer-amplifier system. Refer to the diagram on
page 8 and to the instructions that came with the
components for cabling details.
Route the cables neatly using the cutout at the bottom
and the hollow interior of the vertical supports. Neatly
dress the cables as needed.
Plug the cables into the power strip and plug the
power strip into a power outlet.
Only plug Polycom Media Center components
into the power outlet block. Do not power any
other electrical equipment from this power outlet.

Power Rating:

Voltage rating: 100-240 VAC, 50/60Hz
Maximum power consumption (configured with Group
Series 500 codec and EagleEye IV camera under full
load operating conditions):
Single 55" display:
Dual 55" displays:
Single 65" display:
Single 84" display:
Approximate system weight (including display(s),
codec, camera, and sound system):
Single 55" display:
Dual 55" displays:
Single 65" display:
Single 84" display:
Polycom® RealPresence® Group Series Media Center Setup Sheet
371.4W
491.4W
451.4W
721.4W
505 lbs.
588 lbs.
578 lbs.
600 lbs.
Install the rear panel by inserting the two tabs at the
22
bottom of the panel into the two slots in the base.
Note that this step does not apply to the wall-secured
option.

Regulatory Notices:

 This equipment is intended for indoor use only.
 Only use this equipment with the display(s) supplied by
Polycom.
 Do not use a power cord that is damaged. This could cause
fire or electric shock. Contact the manufacturer for a
replacement cord, if necessary.
 Only use a power cord which is appropriately rated and
approved relevant to the country of use.
 This equipment should be used only on even surfaces.
 When moving or positioning the system, only use the
handles located at the bottom of the display rail at the rear
of the unit.
 This equipment has lockable wheels which should be
applied while the cart is stationary.
 When connecting to the mains supply, connect only to an
earthed supply outlet which is installed near the equipment
and is easily accessible.
 Keep ventilation openings free from any obstructions.
 The ambient operating temperature rating of this equipment
is 0 - 40ºC and should not be exceeded.
 Do not immerse the system in any liquid or place any liquids
on it.
 Do not spray liquids directly onto the system when cleaning.
Always apply the liquid first to a static-free cloth.
 For further information concerning the individual components
of this equipment, please refer to the respective product
literature.
 For support or service, please contact your Polycom®
distributor or go to Polycom Support at
www.polycom.com/support.
7