Regulatory Compliance - UNIVIEW IPC640 Series Quick Manual

The sensor may be burned out by a laser beam, so when any laser

equipment is being used, make sure that the surface of the sensor
not be exposed to the laser beam.
Maintenance
If there is dust on the front glass surface, remove the dust gently

using an oil-free brush or a rubber dust blowing ball.
If there is grease or a dust stain on the front glass surface, clean the

glass surface gently from the center outward using anti-static
gloves or an oil-free cloth. If the grease or the stain still cannot be
removed, use anti-static gloves or an oil-free cloth dipped with
detergent and clean the glass surface gently until it is removed.
Do not use organic solvents, such as benzene or ethanol when

cleaning the front glass surface.
WARNING!
Never look at the transmit laser while the power is on. Never look

directly at the fiber ports and the fiber cable ends when they are
powered on.
Use of controls or adjustments to the performance or procedures

other than those specified herein may result in hazardous laser
emissions.

Regulatory Compliance

FCC Part 15
This equipment has been tested and found to comply with the limits for
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This