Table of Contents
Advertisement
Cable Requirements
Network cable
10/100 Mbps Ethernet CAT5 UTP cables are applicable to the
ANSI/EIA/TIA-568A/B and ISO/D.
Eight wires in the network cable need to be inserted in parallel into the
top of the cable connector. The cable connector needs to be crimped in
position. When the cable connector is in position, ensure that the metal
pieces of the cable connector are parallel to each other and the clamp of
the cable connector is intact.
Optical fiber
The optical module in the camera should match that of the third-party
device (such as a switch), in terms of fiber mode and emission/receiver
wavelength. Ensure the transmission distance of the optical module is
greater than the distance actually required.
NOTE!
For a dome camera with optical module, it should be connected to the
single mode optical fiber instead of multimode optical fiber.
Ensure that the following requirements are satisfied when connecting
two devices using an optical fiber:
When an SFP optical module is connected, the curvature of the
optical fiber should be greater than 90 degrees.
6
Advertisement
Table of Contents
