Start The Camera; Reset The Camera To Default Settings - UNIVIEW IPC640 Series Quick Manual

CAUTION!
When mounting the camera, please install the bracket adapter to

the bracket first and then mount the camera to the bracket.
When stabilizing the bracket, allow sufficient space for the cables

and then tighten the screws. Loose screws may cause the camera to
fall.
The preceding installation process is about concealed installation. To

implement open installation, directly lead the cable out of the
leading-out hole on the flank of the bracket.

Start the Camera

After verifying that the camera is properly mounted, start the camera by
connecting it to power.
Each time the camera is powered on, it will perform a self-test to check
the Pan/Tile/Zoom (PTZ) function. After self-test, you can operate the
camera.
NOTE!
The self-test process starts after the camera is powered up. Please

wait patiently.
When the working temperature is lower than zero Celsius degrees,

the camera will be automatically pre-heated. When the
temperature rises above zero Celsius degrees, the camera will start
the self-test again. It takes a rather long time (at most 30 minutes)
for the camera to finish the pre-heating process.

Reset the Camera to Default Settings

Disconnect the camera from power and then remove the tail cable unit
from the camera. For the camera structure, see
switch that is shown in the figure below, replace the tail cable unit and
then connect the camera to power. The camera is restored to the factory
default settings after the startup.
Figure
36
2-1. Slide the DIP