All The Indicators On The Network Interface Are Off - Canon LBP7100Cn User Manual

0F40-07U

All the Indicators on the Network Interface Are Off

Perform one of the following solutions according to the cause.
<Cause 1> The LAN cable is not connected properly or broken.
Solution 1 Remove the LAN cable once, then connect it again.
Solution 2 Replace the LAN cable with another one, then connect it.
<Cause 2> The cable is connected to the UP-LINK (cascade) port on the hub.
Solution 1 Connect the LAN cable to the port on the hub with an " X " mark.
Solution 2 If the hub has an UP-LINK (cascade) switch, switch to " X ".
<Cause 3> A cross LAN cable is being used.
Solution 1 Replace the cable with a straight LAN cable.
Connect the cross LAN cable to the UP-LINK (cascade) port on the hub. If the hub has an UP-LINK
Solution 2
(cascade) switch, switch to the " = " side.
<Cause 4> Cannot communicate with the hub.
Solution 1 Make sure that the power of the hub is on.
Specify the transmission speed and transfer mode of the printer to match those of the connected hub.
Solution 2
"Specifying the Wired LAN Communication Mode and Transmission Speed"
<Cause 5> The hardware of the printer is in an abnormal condition.
Solution Contact your local authorized Canon dealer to request service.
<Cause 6> If the printer is connected by wireless LAN (LBP7110Cw Only)
Change to a wired LAN connection.
Solution
"Switching Between Wireless LAN and Wired LAN for the Connection (LBP7110Cw Only)"
NOTE
You cannot use a wired LAN and wireless LAN at the same time
When using the printer with a wireless LAN connection, do not connect a LAN cable to the printer. This may result in
malfunction.