Yamaha montage6 Owner's Manual page 50

Recording and Playback
Recording with the click
Follow the steps below to use the click during MIDI
recording.
1
Press the [UTILITY] button and touch [Tempo
Settings] on the screen to call up the Tempo
setting display. Set the Click "Mode" to "Rec."
NOTE
When "Rec/Play" is set, the click sounds during MIDI recording
and playback. When "Always" is set, the click will always
sound.
Re-recording a specific part of a Song
(Punch In/Out)
Use the Punch In/Out recording method to record over only
a specific portion of the Track. If you set the start point
(Punch In) and end point (Punch Out), and then start
recording from the top of the Song, the actual recording
will be done only between the Punch In and Punch Out
points. In the eight-measure example below, only the third
through the fifth measures are re-recorded.
Before re-recording
Recording start
Punch In point
1 2
After re-recording
1 2
NOTE
Note that the Punch In/Out method always replaces (destroys)
the original data over the specified area.
To execute Punch In/Punch Out recording in the above
condition, set the following parameters beforehand on the
Record Setup display.
1 "Record Type": "punch"
2 Punch In: 003:01
Playback of the recording Track is turned off from this
point, and your keyboard performance will be
recorded to the Track.
40
MONTAGE Owner's Manual
Recording stop
Punch Out point
3 4 5 6 7
3 4 5 6 7
Newly recorded data
3 Punch Out: 006:01
Recording ends at this point and normal playback of
the recording Track starts.
1
Cancelling your most recent recording
(Undo/Redo)
The Undo Job cancels the changes you made in your most
recent recording session and restores the data to its
previous state. Redo is available only after using Undo,
and lets you restore the changes you made before undoing
them.
1 Undo (This display is not available if nothing has been
recorded.)
When [Undo] is touched, the display prompts you for
confirmation. Selecting Undo cancels the previous
recording.
2 Redo (This display is not available if Undo has not
been operated.)
When [Redo] is touched, the display prompts you for
confirmation. Selecting Redo restores the change you
made.
2 3
1
2