Wall Mounting The Sbg901 - Motorola surfboard SBG901 User Manual

Wall Mounting the SBG901

Do the following to mount the SBG901 on the wall:
•
Locate the unit as specified by the local or national codes governing residential or
business cable TV and communications services.
•
Follow all local standards for installing a network interface unit/network interface
device (NIU/NID).
If possible, mount the unit to concrete, masonry, a wooden stud, or some other very
solid wall material. Use anchors if necessary (for example, if you must mount the unit on
drywall).
CAUTION: Before drilling holes, check the structure for potential
damage to water, gas, or electrical lines.
Make sure the AC power plug is disconnected from the wall outlet and all cables are
removed from the back of the SBG901 before starting the installation.
You can mount the SBG901 horizontally or vertically. Do the following to mount your
SBG901 on the wall:
1. Print a copy of the
2. Measure the printed template with a ruler to ensure that it is the correct size.
3. Use a center punch to mark the center of the holes.
4. On the wall, locate the marks for the mounting holes.
5. Drill the holes to a depth of at least 1 1/2 inches (3.8 cm). Use M3.5 x 38 mm (#6 x
11/2 inch) screws with a flat underside and maximum screw head diameter of 9.0
mm to mount the SBG901.
6. Using a screwdriver, turn each screw until part of it protrudes from the wall, as
shown in the following wall mounting screw dimensions illustration.
There must be .10 inches (2.5 mm) between the wall and the underside of the screw
head.
7. Place the SBG901 so the keyholes on the back of the unit are aligned above the
mounting screws.
8. Slide the SBG901 down until it stops against the top of the keyhole opening.
2 • Getting Started
Wall Mounting Template.
6.0 mm (.24 inches) maximum
9.0 mm (.35 inches) maximum
2.5 mm (.10 inches).
B
22