Motorola surfboard SBG901 User Manual page 6

•
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
FCC CAUTION: Any changes or modifications not expressly approved by Motorola for compliance
could void the user's authority to operate the equipment.
FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. To comply with the FCC RF exposure compliance requirements, the separation
distance between the antenna and any person's body (including hands, wrists, feet and ankles)
must be at least 20 cm (8 inches).
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The availability of some specific channels and/or operational frequency bands are country
dependent and are firmware programmed at the factory to match the intended destinations. The
firmware setting is not accessible by the end user.
INDUSTRY CANADA (IC) STATEMENT
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the
following two conditions:
1. This Device May Not Cause Interference, and
2. This Device Must Accept Any Interference, Including Interference That May Cause Undesired
Operation of the Device.
This device is designed to operate with two internal antennas as part of the printed wiring board.
The top facing antenna has a maximum gain of 2dBi and the front facing antenna has a maximum
gain of 4dBi.
To reduce potential radio interference to other users, the antenna types and their gains were so
chosen that the equivalent isotropically radiated power (e.i.r.p) is not more than that permitted for
successful communications.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
IC RADIATION EXPOSURE STATEMENT
IMPORTANT NOTE: This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with a minimum
distance of 20 cm between the radiator and your body.
WIRELESS LAN INFORMATION
This device is a wireless network product that uses Direct Sequence Spread Spectrum (DSSS) and
Orthogonal Frequency-Division Multiple Access (OFDMA) radio technologies. The device is
designed to be interoperable with any other wireless DSSS and OFDMA products that comply
with:
•
The IEEE 802.11 Standard on Wireless LANs (Revision B and Revision G), as defined and
approved by the Institute of Electrical and Electronics Engineers
•
The Wireless Fidelity (Wi-Fi) certification as defined by the Wireless Ethernet
Compatibility Alliance (WECA).
i • Safety and Regulatory Information
B
4