Fitting And Replacing Grinding Tools - HTC 800 Classic Manual

Usage
1. Set the handle to the rear position - see
2. Removing the weights.
3. Tip the machine backwards carefully so that it rests on the floor.
4.5

Fitting and replacing grinding tools

Warning!
Disconnect the electrical supply, when changing tools or repairing the machine.
Warning!
The tool becomes very hot during use. Tip the machine back and allow it to
stand for a short while. Use protective gloves when removing the tools.
As the machine is equipped with the patented EZchange tool system, fitting and
replacing grinding tools is quick and easy. The tool system consists of wings on which
diamond grinding tools are fitted without the need for screws.
14
Figure 4-1, page 12
HTC 800 Classic
1.0