Preparations For Wet Grinding - HTC 800 Classic Manual

HTC 800 Classic
1. Connect a dust extractor to the machine. For dust extractor models, see under the
Suction System tab in the HTC Product Catalogue.
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3. Attach the appropriate tool to the machine, see under
page 15
4. Set the handle to the working position,
4.7

Preparations for wet grinding

Warning!
Check that the splash guard is fitted.
1. Always use liquid suction when wet grinding.
2. Inspect the floor carefully and remove any objects sticking up, such as
reinforcement rods or bolts, and any debris that could get caught in the machine.
3. Attach the appropriate tool to the machine.
4. Set the handle to the working position,
5. Fill the tank with cold water.
6. Turn the tap on the left side of the machine to the open position.
7. Turn the tap to the closed position once wet grinding is finished.
1.0
Note!
The dust extractor's suction hose must be connected to the appropriate
socket on the machine. Adjust the dust extractor to match the grinder's
capacity.
Tip!
Never use a dust extractor, as blockages may develop in the dust
extractor's suction hose and filter.
Warning!
Only use cold water with no chemical additives.
Fitting grinding tools,
see Figure 4-1, page 12.
see Figure 4-1, page 12.
Usage
17