Introduction - AEMC CM605 User Manual

These safety warnings are provided to ensure the safety of personnel
and proper operation of the instrument.
• Read the instruction manual completely and follow all safety infor-
mation before operating this instrument.
• Only use leads that comply with the IEC/EN 61010. Before using
them, make sure that they are in safe working order.
• Only use factory supplied leads.
• Never exceed the protection limit values indicated in the specifica-
tions for each type of measurement.
• Never measure current while the test leads are connected to the
input jacks.
• Use extreme caution when measuring live systems with voltages
greater than 50V
• Do not perform resistance or continuity tests on a live circuit.
• Use extreme care when working around bus bars and bare conduc-
tors.
• Do not use the meter in overrange/overload conditions (OL).
• When the multimeter clamp is linked to the measurement circuits,
do not touch any unused terminals.
• Before changing the function, disconnect the measurement leads
from the circuit measured.
2
CHAPTER 1

INTRODUCTION

Warning
or 30V .
DC AC
AC Clamp-on Meter Model CM605