Delta Amplon UPS102N2000B035 User Manual page 14

Multi-
No. function
Button
2
3
Amplon N Series
The button has multi-function. Please refer to the following for de-
tailed information.
1. Turn-off:
In on-line mode, press and hold the button for 3 seconds,
z
z
release it after you hear one beep and the inverter will be off
and the UPS will transfer to run in standby/ bypass mode.
The UPS will keep charging the batteries when the UPS is in
standby mode even though the button has been pressed. To
fully turn off the UPS, it is advised to unplug the input power
cord.
In battery mode, press and hold the button for 3 seconds, re-
z
z
lease it after you hear one beep and the UPS will turn off its
output.
2. Fault Clear:
When the UPS has a fault condition, press and hold the button
for 3 seconds, release it after you hear one beep and the UPS
will clear the fault condition and return to standby mode. Besides,
the LCD will show the relevant error code. For error code infor-
mation, please refer to 3.3 LCD Display - No. 9.
3. Scrolling down:
In setup mode, press the button for 0.1 second to go to the next
display.
The button has multi-function. Please refer to the following for de-
tailed information.
1. Scrolling down:
In non-setup mode, press the button for 0.1 second to go to the
next display.
2. Entering into the setup mode:
Press the button for 3 seconds and the UPS will enter into the
setup mode. For more information, please refer to 5.5 Setup
Mode. Please note that only qualified service personnel can per-
form setup action.
Description
1 0