Internal Usb Key - Dell PowerEdge M630 Owner's Manual

3. upper card slot (SD 2)
Next steps
1. Follow the procedure listed in
2. Enter the System Setup and ensure that the Internal SD Card Port and Internal SD Card
Redundancy mode is enabled.
3. Check if the new SD card is functioning properly. If the problem persists, see

Internal USB key

The server module provides an internal USB connector for a USB flash memory key. The USB memory
key can be used as a boot device, security key, or mass storage device. To use the internal USB
connector, the Internal USB Port option must be enabled in the Integrated Devices screen of the System
Setup.
To boot from the USB memory key, you must configure the USB memory key with a boot image, and
then specify the USB memory key in the boot sequence in the System Setup. For information on creating
a bootable file on the USB memory key, see the user documentation that accompanied the USB memory
key.
Replacing the internal USB key
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To avoid interference with other components in the server module, the maximum
permissible dimensions of the USB key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Ensure that you read the
2. Follow the procedure listed in
Steps
1. Locate the USB connector/USB key.
2. If installed, remove the USB key.
3. Insert the new USB memory key into the USB connector.
58
After working inside your
Safety instructions.
Before working inside your
4. lower card slot (SD 1)
system.
Getting
system.
Help.