Installing And Removing Server Module Components; Safety Instructions; Before Working Inside Your System; After Working Inside Your System - Dell PowerEdge M630 Owner's Manual

Installing and removing server module
components
This section provides information on installing and removing the server module components. For
information on installing and removing the enclosure components, see the enclosure Owner's Manual at
dell.com/poweredgemanuals.

Safety instructions

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: It is recommended that you always use a static mat and static strap while working on
components inside the system.
NOTE: To ensure proper operation and cooling, all bays in the system must be populated at all
times with either a system component or with a blank.

Before working inside your system

1. Turn off the server module using the CMC.
2. Remove the server module from the enclosure.
3. Install the I/O connector cover.
4. Remove the system cover. See

After working inside your system

1. Install the system cover. See
2. Install the server module in the enclosure.
3. Turn on the server module.

Recommended tools

You may need the following items to perform the procedures in this section:
• #1 and #2 Phillips screwdrivers
• T8 and T10 Torx drivers
• Wrist grounding strap
• Hex nut driver-5 mm
36
Removing the system
Installing the system cover.
cover.
4