Advertisement
STEP 14
Install both undercarriage legs ensuring that they push down
fully into their slots.
STEP 15
Locate the undercarriage retaining saddle clamps. Note that
two are used per leg. Pilot drill the undercarriage mounting
blocks for the clamps - one at the inner and one at the outer
end of the leg - and retain with the wood screws supplied.
STEP 16
Fit the wheels using the collets supplied. File or grind
a flat on the axle where the point of the grub screw
contacts to reduce the risk of it slipping. Ensure the wheel
spins freely and using threadlock, tighten the grubscrew
securely. Repeat for the other wheel.
STEP 17
Locate the wing joining brace. Note the orientation - the
top of the brace is straight and the bottom has a slight
dihedral angle. Measure and mark a centre-line on the
joining brace.
STEP 18
Coat the inside of the corresponding slot in the wing
panel and one half of the brace with 5 minute epoxy.
Ensure that adequate epoxy is used to fully cover
all surfaces.
Page 5
Advertisement
