Advertisement
STEP 9
Using side cutters, trim off any excess screw thread that
passes through the moulded horn plate.
STEP 10
Use a small length of tape to hold each of the ailerons
at their neutral position while you complete the aileron
linkages. Ensure that both aileron servos are centred.
With the pushrod connected to its horn, mark the position
the control rod passes over the servo's output arm. Bend
the pushrod up at 90° at this point.
STEP 11
Trim off the excess pushrod wire using side cutters.
Repeat the procedure for the second aileron in exactly
the same way.
STEP 12
Now slide each aileron servo horn over their respective
pushrods and re-fit to the servo. Adjust the pushrods to
ensure that the ailerons are centred with the aileron servos
at their neutral position. Test to ensure that both ailerons
move freely across their entire throw then snap a moulded
keeper onto the pushrod to retain it as shown.
STEP 13
Locate the pre-cut grooves in the hardwood undercarriage
mounting blocks. Carefully cut the covering at this point
to allow the undercarriage legs to insert into the mounting
blocks.
Page 4
Advertisement
