Advertisement
STEP 44
Hold your engine steady and mark the positions of the
mounting holes on the mount.
STEP 45
Remove the engine and pilot drill four holes through the
engine mounting beams to suit the self tapping screws
supplied. Screw the engine to the mount.
STEP 46
Locate the nosewheel mount and screw it in position on
the bulkhead using the self tapping screws provided.
STEP 47
Prepare the noseleg by installing the wheel with the collet
supplied. File or grind a flat on the axle where the point of
the grub screw contacts to reduce the risk of it slipping.
Ensure the wheel spins freely and tighten the grubscrew
securely.
STEP 48
Locate the steerable noseleg pushrod and install the
moulded steering arm onto the z-bent end. Insert the
pushrod into its tube, then holding the steering arm
in position, slide the noseleg into its mount. Ensuring
that the steering arm is straight, tighten the retaining
grubscrew with an allen driver.
Page 11
Advertisement
