Advertisement
STEP 49
Screw a plastic snap link onto the end of the throttle
pushrod. Slide the pushrod into its outer and connect the
snap link to the carburettor throttle lever. Retain using a
short length of fuel tube as shown.
STEP 50
You can now install your servos in the pre-fitted servo
tray. Note the servos' orientation and after pilot drilling
the tray and fitting the rubber grommets and brass
ferrules supplied with your servos, install them using the
screws supplied with your radio.
STEP 51
Feed a scrap length of snake outer tube through the fuselage
from rear to front to aid guiding the rudder pushrod
throughout the fuselage and out through its slot under
the tail.
STEP 52
Using the snake outer to lead it through, feed the rudder
pushrod through the fuselage and out through its exit.
STEP 53
Now screw a nylon clevis onto the pushrod as shown.
Connect to a control horn and holding the horn in line with
the rudder hinge line, mark and pilot drill two mounting holes
in the rudder.
Page 12
Advertisement
