Advertisement
STEP 59
The tank is installed in its bay via the radio bay. Fit and
identify your fuel tubes, then feed the tank into position,
drawing the fuel tubes out through the hole in the centre
of the firewall. Connect the fuel line to your engine,
pressure line to the silencer and blank off the vent line.
STEP 60
Connect and install your receiver in the radio bay with
plenty of shock absorbing foam. Temporarily install
your radio's battery in the radio bay. Its final position is
determined after balancing the model.
STEP 61
Make a card template to clear the shape of the engine and
tape it in position on the fuselage as shown.
Temporarily remove the engine.
STEP 62
Prepare the cowl by adding strips of masking tape to aid
marking it for cutting. Slide the cowl in place and transfer the
shape to be cut out using a felt tip pen.
STEP 63
Now remove and trim the fibreglass cowl to clear the engine
and silencer using the shape you transferred as a guide.
The engine can now be re-fitted.
Page 14
Advertisement
