Advertisement
STEP 54
Now screw the horn to the rudder.
STEP 55
The screws thread into the moulded horn plate on the other
surface of the rudder.
STEP 56
Carry out the above 5 steps again to complete the
elevator linkage.
STEP 57
Move to the radio bay and complete each linkage
by screwing on a nylon clevis and connecting to the
appropriate servo. Note that the steerable noseleg
pushrod connects to the same side of the rudder
servo horn, inboard of the the rudder pushrod. The
throttle linkage uses a steel pushrod connector for easy
adjustment.
STEP 58
Prepare the fuel tank for fitting by assembling the tank
stopper with the feed, vent and fuel pipes. Ensure the
clunk tube length is cut to allow the clunk to move around
the tank without catching on the tank's base. Fit the
assembled tank bung and tighten the retaining screw. Take
care not to over-tighten this screw. Test that the tank is
leak-proof.
Page 13
Advertisement
