Advertisement
Congratulations on your purchase of the Bullet ARTF - the first Almost Ready to Fly version of this classic low-
winger. Based on the original and timeless Bullet design, the new Ripmax Bullet ARTF has been scaled up by 10%
to make to most of today's more powerful engines. This also gives a lighter wing loading and improved flying
characteristics.
Assembly is quick and easy, but before commencing construction, please ensure that you read these instructions
in their entirety.
STEP 1
Locate the pre-cut servo apertures in the underside of the
wing. Carefully trim away the covering to expose these
apertures using a sharp knife.
STEP 2
Check the fit of your chosen aileron servos in the apertures
and adjust with a sharp knife if necessary. Prepare your
servos by connecting a suitable 300mm extension lead to
each. It is a good idea to use a lead-lock, a turn of insulation
tape or heatshrink tube over the joint for additional security.
Fit the rubber grommets and brass ferrules supplied with
your servo.
STEP 3
Pilot drill the mounting holes for each servo.
Page 2
Advertisement
