Kingsman ZVFB2410MVN Owner's Operation And Installation Manual

Unvented (vent-free) firebox

Advertisement

Quick Links

UNVENTED (VENT-FREE) FIREBOX
ZVFB2410MVN, ZVFB2410MVP, ZVFB2426MVN, ZVFB2426MVP
and Installation Manual
Warning
Carefully review the instructions
supplied with the decorative type
unvented room heater for the
minimum size requirement.
DO NOT INSTALL THE APPLIANCE
IN THIS FIREBOX UNLESS THIS
FIREBOX MEETS THE MINIMUM
DIMENSIONS REQUIRED FOR THE
INSTALLATION
If the information in this manual is not followed
exactly, a fire or explosion my result causing property damage,
personal injury, or loss of life.
– Do not store or use gasoline or other flammable vapors and liquids in
the vicinity of this or any other appliance.
– WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone. Follow
the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
– Installation and service must be performed by a qualified installer,
service agency, or the gas supplier.
This is an unvented gas-fired heater. It uses air (oxygen) from the
room in which installed. Provisions for adequate combustion and
ventilation must be provided. Refer to Page 7.
Save this manual for future reference • 2340 Logan Ave., Winnipeg, MB, Canada, Phone: (204) 632-1962 • Printed in Canada • PART #24VF-MAN
Circulating Models
Listed Certified for USA
Burner Systems are approved to: ANSI Z21.11.2-2007
for the ZVF24 Vent Free Firebox only
Owner' s Operation
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
This appliance must be
installed by a licensed
plumber or gas fitter in
the Commonwealth of
Massachusetts and meet
the requirements of 527
CMR 30 and 248 CMR.
Warning
Warning
Rev. July 24, 2008
ZVF24
A LISTED GAS-FIRED UNVENTED
DECORATIVE ROOM HEATER
DO NOT BUILD A WOOD FIRE
Improper installation, adjustment,
alteration, service, or maintenance
can cause injury or property
damage. Refer to this manual for
correct installation and operational
procedures. For assistance or
additional information consult a
qualified installer, service agency, or
the gas supplier.
The ZVF24 Firebox is to be used
only with certain vent-free gas log
heaters (see Page 20). Do not burn
wood or other materials in these
fireboxes.
1
Warning
FOR USE ONLY WITH
NOT TO EXCEED
40,000 BTU/H.
Warning
Warning

Advertisement

Table of Contents
loading

Summary of Contents for Kingsman ZVFB2410MVN

  • Page 1 UNVENTED (VENT-FREE) FIREBOX Circulating Models ZVF24 Listed Certified for USA ZVFB2410MVN, ZVFB2410MVP, ZVFB2426MVN, ZVFB2426MVP Burner Systems are approved to: ANSI Z21.11.2-2007 for the ZVF24 Vent Free Firebox only Owner’ s Operation and Installation Manual INSTALLER: Leave this manual with the appliance.
  • Page 3: Table Of Contents

    TABLE OF CONTENTS SECTION PAGE Table of Contents ..................3 PreInstallation Questions and Answers .
  • Page 4: Preinstallation Questions And Answers

    PRE-INSTALLATION QUESTIONS and ANSWERS About curing of the paint Your stove or fireplace has been painted with the highest quality silicone stove paint. This paint dries quickly in 15-20 minutes when first applied at the factory. However, due to the high temperature silicone components, the paint will cure when heat is applied to the appliance as it is first used.
  • Page 5: Safety Information

    SAFETY INFORMATION WARNINGS WARNINGS Important: Read this owner’s manual carefully and completely before trying to assemble, operate, or service this firebox. Improper use of this firebox can cause serious injury or death from burns, fire, explosion, electrical shock, DANGER and carbon monoxide poisoning. Early signs of carbon monoxide poisoning resemble the CARBON MONOXIDE POISONING flu, with headaches, dizziness, and / or nausea.
  • Page 6: Local Codes

    SAFETY INFORMATION WARNINGS Cont. 15. Isolate the appliance from the gas supply piping system by closing its individual manual shut off valve during any pressure testing of the the gas supply piping system at test pressure equal or less than 1/2 psig. 16.
  • Page 7: Air For Combustion And Ventilation

    AIR FOR COMBUSTION AND VENTILATION Today’s homes are built more energy efficient than ever. New materials, increased insulation, and new construction methods help reduce heat loss in homes. Home owners weather strip and caulk around windows and doors to keep the cold air out and the warm air in.
  • Page 8 AIR FOR COMBUSTION AND VENTILATION Cont. 1. Determine the volume of the space (length x width x height). Length x Width x Height = ______________ cu. ft. (volume of space) Example: Space size 22ft. (length) x 18 ft. (width) x 8 ft. (ceiling height) = 3168 cu. ft. (volume of space) If additional ventilation to adjoining room is supplied with grills or openings, add the volume of these rooms to the total volume of the space.
  • Page 9: Ventilation Air From Inside Building

    AIR FOR COMBUSTION AND VENTILATION Cont. VENTILATION AIR FROM INSIDE BUILDING This fresh air would come from an adjoining unconfined space. When ventilating to an adjoining unconfined space, you must provide two permanent openings: one within 12” of the ceiling and one within 12” of the floor on the wall connecting the two spaces.
  • Page 10: Fireplace Dimensions

    ZVF2410-2426 FIREPLACE DIMENSIONS...
  • Page 11: Framing Specifications

    ZVF2410/2426 FRAMING SPECIFICATIONS...
  • Page 12: Installing By Framing Fireplace

    INSTALLING – Framing CAUTION INSTALLING BY FRAMING FIREPLACE Do not install the firebox on carpet or vinyl. Built-in installation of this firebox involves installing firebox into a framed-in enclosure. Optional brass trim accessories are available. The brass trim will extend past sides of firebox. This will cover the rough edges of the wall opening.
  • Page 13: Installing Firebox Using Optional Pre-Built Mantel Cabinets

    INSTALLING – Mantel Cabinets INSTALLING FIREBOX USING OPTIONAL PRE-BUILT MANTEL CABINETS This firebox may be installed using a cabinet mantel accessory against a wall in your home. The firebox and cabinet mantel can be installed directly on the floor. 1. Assemble cabinet mantel. Assembly instructions are included with each accessory.
  • Page 14: Installing Clearances

    INSTALLING – Clearances NOTICE A qualified service person must install firebox. Follow all local codes. WARNING WARNING Never install the firebox • in a bedroom or bathroom • in a recreational vehicle • where curtains, furniture, clothing, or other flammable objects are less than 42 inches from the front, top, or sides of the firebox •...
  • Page 15: Installing Z33Fk Fan Kit

    INSTALLING Z33FK– Fan Kit WARNING WARNING WARNING Electrical Grounding Instructions - This A qualified electrician must Label all wires prior to appliance is equipped with a three - pronged connect electrical wiring to disconnection when servicing junction outlet for built-in (grounding) plug for your protection against controls.
  • Page 16: Installing Zvf2410 & Zvf2426 Brick Panel

    ZVF2410 & ZVF2426 Brick Panel Installation 1. Remove Deflector Hood by tilting front of hood up and pulling towards you. 2. Remove Pull Screens & Rods from fireplace. 3. Remove accessories, Overlays, Designer Doors, and or Logs if installed. 4. Place Rear Brick Panel up against the back of the firebox, ensuring the notched portion is at the bottom, and the beveled edge is at the top.
  • Page 17: Trim Assembly & Installation

    TRIM ASSEMBLY AND INSTALLATION 1. Slide the two top support tabs into slot of top trim piece as shown. (Fig.1) 2. Place two part L brackets and backing plates into 45 degree cut ends of trim and tighten screws. If this is a four piece trim repeat for bottom assembly.
  • Page 18: Overlay & Designer Door Installation

    OVERLAY & DESIGNER DOOR INSTALLATION Warning: Fireplace screen must be closed while appliance is in operation. Overlay Door Installation 1. Remove deflector hood by tilting front of hood up and pulling towards you. 2. Do not remove woven mesh screen. Screen will hang behind overlay door. 3.
  • Page 19: Installing Burner System

    Field conversion is not permitted. property damages or personal injury. Burner Model Valve Type Fuel Type BTU - Input Min/Max Inlet Manifold Pressure Orifice Size Primary Air ZVFB2410MVN Millivolt Natural Gas 10,000 non-adjustable 5.5”/10” 3.5” 1/32” open ZVFB2410MVP Millivolt Liquid Propane 10,000 non-adjustable 11”/13”...
  • Page 20: Log Placement

    LOGF10 PLACEMENT FOR ZVF24 Warning: Failure to position parts in accordance with these diagrams or failure to use only part specifically approved with this heater may result in property damages or personal injury. Log Attachment Points Log components 1. Place log #1 against the back wall of the unit. Center 2.
  • Page 21: Millivolt Lighting Instructions

    MILLIVOLT LIGHTING INSTRUCTIONS...
  • Page 22: Troubleshooting

    TROUBLESHOOTING WARNING Turn off and let cool before servicing. Only a qualified NOTE: all troubleshooting items are listed in order of service person should service and repair heater. operation. When igniter button is pressed, there is no spark at ODS/Pilot. Possible Cause Remedy 1.
  • Page 23: Illustrated Burner Parts List

    ILLUSTRATED BURNER PARTS LIST ABCD REGULATOR NG ONLY ZVFB2410MVN/ZVFB2410MVP/ZVFB2426MVN/ZVFB2426MVP Ref No. Part Number Description 2410-Burner 10,000 BTU Burner c/w non-adjustable locking tab 2426-Burner 26,000 BTU Burner 2426-116 Burner Pan 2426-GRATE Grate Assembly 2426-117 Control Panel 2426-126 Pilot Bracket 4200-132 Burner Hold Down...
  • Page 25: Parts List & Accessories

    PART NUMBERS DESCRIPTION ZVF24 Zero Clearance 24” Vent Free Fireplace listed for USA complete with pull screens BURNER SYSTEMS ZVFB2410MVN Millivolt Valve 10,000 BTU/HR Natural Gas non-adjustable c/w lock ZVFB2410MVP Millivolt Valve 10,000 BTU/HR Liquid Propane non-adjustable c/w lock ZVFB2426MVN...
  • Page 26: Limited Lifetime Warranty

    During the first year after installation, we will provide a replacement for any component part of your unit found to be defective in materials or workmanship, including labour costs. Repair work requires prior approval by Kingsman, labour costs are based on a predetermined rate schedule and any repair work must be done through an authorized Kingsman dealer.

This manual is also suitable for:

Zvfb2410mvpZvfb2426mvnZvfb2426mvp

Table of Contents