First Print - Flashforge ADVENTURER 3 V2 Quick Start Manual

Build
Tools
Filament
1. Tap [Filament], tap [Load], after load completed, tap [OK].
235
Preheat completed,
Begin loading...
ok

First Print

2. As shown on the left, loading starts when the
extruder heated to target temperature.
/235℃
3. Open the filament cover, insert the filament into the
filament intake, push filament into the feeding wheel
until some resistance is sensed.
Note: Please make sure filament has been pushed into
the feeding wheel!
Load
Change
06
200
/235℃
Heating extruder...
Cancel