Outline; Warning Table; Warnings; Error Table - Canon iPF700 Series Service Manual

8.1 Outline

8.1.1 Outline
The printer indicates errors using the display and LEDs.
If an error occurs during printing, the printer status is also displayed on the status monitor of the printer driver.
The following three types of errors are displayed on the display:
- Warning
Status where the print operation can be continued without remedying the cause of the problem. This can, however, adversely affect the printing results.
- Error
Status where the print operation is stopped, and the regular operation cannot be recovered until the cause of the problem is remedied.
- Service call error
When a service call error occurs, the error is not cleared and the error indication remains on the operation panel even if the printer is powered off and on again.
(Occurrence of the service call error is indicated again at power-on.)
This measure is taken to prevent user's recovery of the service call error and damages to the printer.
Service call errors can be cleared, however, by starting up the printer in the service mode.
For how to take actions against warnings and errors, refer to "Troubleshooting".
Overview of warnings and error codes
* "x" stands for a numeric or letter.

8.2 Warning Table

8.2.1 Warnings

The codes correspond to the numbers shown on the DIPLAY in the service mode.
Code Display massage
1000 Ink Lv1: Chk
1001 Ink Lv1: Chk
1002 Ink Lv1: Chk
1003 Ink Lv1: Chk
1006 Ink Lv1: Chk
1007 Ink Lv1: Chk
100F Feed Limit...
1010 Check printed document.
1100 Check maint cartridge capacity.
1221 GARO W1221
1222 GARO W1222
1223 GARO W1223
1225 GARO W1225
1231 GARO W1231
1232 GARO W1232
1233 GARO W1233
1234 GARO W1234
1235 GARO W1235
Prepare for parts replacement. Call for service.
Parts replacement time has passed. Call for service.

8.3 Error Table

8.3.1 Error Code List

The codes correspond to the numbers shown on the DISPLAY in the service mode.
Code*
03010000-200C
03010000-200D
03010000-200E
03010000-200F
Code* Diagnosis
W100x Ink warning
W110x Waste ink warning
W12xx GARO warning
03xxxxxx-20xx Media feeding error
Data mismatch error
03xxxxxx-2Exx
03xxxxxx-25xx Ink error
03xxxxxx-280x Printhead error
03xxxxxx-281x Maintenance cartridge error
03xxxxxx-282x Adjustment error
03xxxxxx-2Fxx Other errors
Exxx-40xx Service call error
Description
Media leading edge not detected
The trailing edge of cut sheet cannot be detected
Too small media
Too large media
T-8-1
T-8-2
Status
BK ink tank is almost empty
Y ink tank is almost empty
M ink tank is almost empty
C ink tank is almost empty
MBK ink tank is almost empty
MBK2 ink tank is almost empty
Force feed limit
Ink non discharging
Maintenance cartridge is almost full
Unsupported command in GARO image mode
Invalid number of parameters in GARO image mode (no parameter)
Required item was omitted in GARO image mode
Other warning in GARO image mode
Unsupported command in GARO setting mode
Invalid number of parameters in GARO setting mode
Reauired item was omitted in GARO setting mode
Data out of range in GARO image mode
Other warning in GARO setting mode
Parts counter warning level 1
Parts counter warning level 2
T-8-3
Chapter 8
0014-1949
0014-1952
0014-1956
8-1