Troubleshooting/Technical Specifications - Permobil Remote Stopping Device Owner's Manual

Remote Stopping Device
Troubleshooting guide
The following troubleshooting guide describes a number of errors and events
that could occur when using your remote stopping device, together with sug-
gested corrective action. Please note that this guide cannot describe all the
problems and events that may occur and you should always contact your ser-
vice contact or Permobil in case of doubt.
EVENT
The wheelchair will not lock/.
unlock.
The wheelchair locks and
unlocks itself without the
transmitter having been
pressed.
If the transmitter breaks while the chair is locked, it is possible to unlock the
chair by cutting off the power, e.g. by disconnecting the main fuse or undoing
one of the cables to the battery.
Technical specifications
General
Name ............................................................................... Permobil Remote Stopping Device
Electrical system
Voltage ........................................................................... 24V
Frequency........................................................................ 315MHz (US) or 433.92MHz (EU)
Range .............................................................................. Up to 30m (100ft)
Battery hand unit ............................................................. 12V Alkaline LR23A
POSSIBLE CAUSE
The chair is out of range.
The hand unit battery is dead.
There is another transmitter
in the area.
DATA
36
United Kingdom
ACTION
Move nearer.
Replace the battery.