Permobil Remote Stopping Device Owner's Manual page 14

User Guide Remote Stopping Device
Design & Function
Programming the unit
Programming a new button code on channel 1 (Channel 2 is not used)
1.
Press down button #1 next to the text "Mode switch" on the receiver box for
three seconds. The green diode rapidly begins to flash.
2.
Press the "I" button on the transmitter box. The green diode will flash on and
then off again to verify that the button's function has now been programmed.
NB! The green diode flashes for a maximum of 15 seconds. If no button on the
transmitter has been pressed during this time, the receiver exits programming
mode and the green diode will go off.
Important information on code programming
The receiver can only be programmed with a code from one specific button
once. If you attempt to program in a new button code when the button code has
already been programmed in, the receiver will exit programming mode regard-
less of whether it is the same channel or not.
In order to delete all programmed codes: press "Mode switch button" #1 for three
seconds. When the diode starts to flash, press the same button again for three
seconds. The LED will now flash twice to verify that all codes that had been
programmed in have now been deleted.
Receiver box
14
USA